How to Keep Your G1TM Kennel Mossy Oak Bottomland Camo Clean

By GUNNER | Published: 2026-11-04

Category: Mẹo & Chăm sóc

A practical routine for cleaning and maintaining your G1TM Kennel in Mossy Oak Bottomland so the camo finish stays sharp and the kennel stays ready for the field.

Quick answer

Clean your G1TM Kennel in Mossy Oak Bottomland with mild soap and water, rinse thoroughly, and dry it completely before storage. Avoid harsh chemicals and abrasive tools that can dull the camo pattern or damage the finish.

Why the Bottomland pattern needs a gentler routine

The Mossy Oak Bottomland pattern on the G1TM Kennel is applied to a Gunmetal finish, and while the kennel is built for tough use, the camo surface can wear prematurely if you treat it like bare metal. Abrasive pads, solvent-based cleaners, and high-pressure washes can fade the pattern or leave dull spots. A simple, consistent routine preserves both the look and the protective finish.

When to clean beyond the routine

After a wet, muddy hunt, don’t wait for your regular cleaning day. Mud and moisture trapped in crevices can harbor odor and, over time, affect the finish. Rinse and dry the kennel as soon as practical, and give extra attention to the latch and hinge areas where debris collects.

Step-by-step camo kennel cleaning routine

Remove loose debris: Before wetting the kennel, brush out dirt, hair, and grass with a soft-bristled brush or vacuum. Pay attention to the inside floor and the area around the door latch. Skipping this step can turn mud into a muddy paste that is harder to rinse away.
Wash with mild soap and water: Use a solution of gentle dish soap and warm water. Wipe down all surfaces with a soft cloth or sponge, including the camo panels and the frame. Do not use abrasive cleaners or scouring pads. Harsh chemicals can dull the Mossy Oak pattern and leave streaks.
Rinse thoroughly: Rinse with clean water using a low-pressure hose or a bucket. Make sure no soap residue remains, especially in the corners and along the bottom edge. Soap left to dry can attract dirt and leave a film that dulls the finish.
Dry completely: Towel-dry the kennel and then leave it in a well-ventilated area to air dry fully before use or storage. Prop the door open to let air circulate inside. Trapped moisture can cause odors and, over time, affect metal components.
Inspect and store smart: Check the latch, hinges, and camo surface for wear or damage. Store the kennel indoors or in a dry, covered area when not in use. Regular inspection catches small issues before they become bigger problems.

Product facts

G1™ KENNEL - MOSSY OAK BOTTOMLAND GUNMETAL: The G1TM Kennel in Mossy Oak Bottomland Gunmetal is available in Small, Medium, Intermediate, and Large sizes. Size-specific cleaning access matters—smaller kennels have tighter corners that need a soft brush, while larger sizes may require a longer reach.
G1™ KENNEL - MOSSY OAK BOTTOMLAND GUNMETAL